Electrical Industry Articles and Stories

Wall pack lighting is installed on the exterior walls of buildings where it provides needed illumination to ensure safety and security. This type of fixture is perfect for parking lots, pathways, exits, entrances, or wherever nighttime visibility is crucial.

Look up in most U.S. kitchens and you’ll likely see recessed downlights shining back at you. These fixtures have been the go-to option for decades – not just in kitchens, but throughout the house – for providing area lighting that doesn’t interrupt a ceiling’s clean lines

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

Occupancy sensors are quickly becoming a regulatory requirement in many commercial spaces, thanks to evolving energy codes seeking to wring out kilowatt-hours of energy savings anywhere it’s possible.

A decade ago, LED lighting was still fighting for acceptance among designers, contractors and consumers. Early product generations suffered from quality control problems, flickering and light that was too far into the blue end of the visual spectrum.

There it is again! That cat’s chasing rabbits in my garden again tonight. I knew something was tearing things up in there at night, so I installed a set of solar powered floods on the top of the gate.