Electrical Industry Articles and Stories

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

Up until three years ago, I lived with a couple small boxes of spare fuses that sat on top of the water heater in the basement, ready to be drawn from should the rare combination of, say, the toaster and microwave operating at the same time happen to shut down power to the kitchen.

In a world where electrical efficiency and streamlined design are of primary concern, the mini power center is quickly becoming a staple piece of equipment for electricians, general contractors, and electrical industry experts. It's small, it's powerful, and it's reshaping the way we manage electricity, on the jobsite and in the facilities we serve.

I'm working on upgrading the electrical outlets around the outside of our house. In addition to adding more receptacles around the perimeter, I'm finally getting around to "electrifying" the shed and lean-to in the backyard.

It’s hard to believe that it was just three years ago that much of the country was on red alert status thanks to Covid. Researchers were still learning more about the new virus, but one thing they were sure of was that it spread through the air, which made air purification systems a new priority for any place people gathered in large numbers.

Rooftop support systems are an integral part of conduit, piping, and mechanical installations that often go underappreciated. These unsung heroes of the rooftop world provide a stable and secure foundation for equipment, ensuring that everything from HVAC units to solar panels stays in place, regardless of weather conditions or external forces.