Electrical Industry Rich-Media Product Demos and Videos

One of the most critical decision when designing stable and safe electrical systems is system grounding. The key parameter that determines the neutral grounding resistor’s affect on the circuit is the let-through current. This video will focus on how to determine what level of let-through current to specify when designing a resistance-grounded system.

For critical HVAC application needs, leading brands rely on Littelfuse with nearly 100 years of experience. From overload to overcurrent, and accuracy to durability, we have your equipment needs covered with protection, control and sensing components to enhance your overall HVAC system performance.

Learn how to provide personnel protection and safety in your commercial kitchen with the SB5000 Shock Block® that meets the NEC GFCI requirements and offers ground-fault protection for three-phase loads for all plug-in equipment 100 amperes and below.

Voltec's EXTREME All-Weather extension cord has been tested from Maine to Alaska - in the harshest conditions including ice and snow - from the oil fields up to the mountains. No temperature nor terrain can outlast EXTREME!

The Littelfuse POWR-SPEED™ fuse line are certified high-speed fuses optimized for performance and efficiency to better protect your critical power semiconductors against short circuits.
Littelfuse.com/POWRspeed

Learn more about our innovative SuperFlex post top and bollard lamps with this quick video!

Save time and money! Arlington’s low cost MC cable fittings in a variety of sizes, are super-convenient and cost-effective. Each fitting has a built-in end stop, but also comes with additional end stop bushings that accommodate different size cable bundles. ONE trade size fits several cable sizes!

LED's new Troffer Transformer has the ability to be installed as a retrofit kit or as a new fixture. Choose between volumetric or flat panel design.

Installation is quick and easy. Using the reference scale attach the retaining clips to the cover with the supplied screws. Push the assembled cover into the hole and adjust the fit by moving one of the retaining clips slightly in or out.