Electrical Industry Articles and Stories

Keeping hospital balance sheets profitable is a challenging proposition for healthcare organizations. That’s certainly one reason why so many have undertaken lighting upgrades over the last decade to move to more efficient LED lamps and fixtures.

Lighting the great outdoors requires a bit more thought now than it did a couple decades ago. The goal used to be simply packing as many lumens as possible into a landscape fixture. That was the entire point. Photocell sensors might have been used to ensure lights didn’t stay on during daylight hours, but keeping outdoor space fully illuminated – even when no humans were around – was seen as a key safety measure.

Uncle Bob and Aunt Betty's two-story farmhouse was a haven for my brother and me during our childhood. While it didn't boast modern amenities, the old-fashioned radiators under each window ensured a cozy warmth throughout the house. These radiators were a blessing during cold winters, providing a spot to dry our snow-soaked gloves.

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

In a world where electrical efficiency and streamlined design are of primary concern, the mini power center is quickly becoming a staple piece of equipment for electricians, general contractors, and electrical industry experts. It's small, it's powerful, and it's reshaping the way we manage electricity, on the jobsite and in the facilities we serve.

I'm working on upgrading the electrical outlets around the outside of our house. In addition to adding more receptacles around the perimeter, I'm finally getting around to "electrifying" the shed and lean-to in the backyard.