Electrical Industry Rich-Media Product Demos and Videos

Save time and money with Arlington's liquid-tight, concrete-tight fittings designed especially for PVC jacketed MC cable - and Tech 90 cable.

Arlington's non-metallic hole cover kits offer the fastest way to cover a hole and ensure compliance with OSHA safety standards on a multi story building site.

Save time and money! Arlington’s low cost MC cable fittings in a variety of sizes, are super-convenient and cost-effective. Each fitting has a built-in end stop, but also comes with additional end stop bushings that accommodate different size cable bundles. ONE trade size fits several cable sizes!

Installation is quick and easy. Using the reference scale attach the retaining clips to the cover with the supplied screws. Push the assembled cover into the hole and adjust the fit by moving one of the retaining clips slightly in or out.

Arlington's smaller, 5" x 7" Exterior Mounting Base, is designed for easy use. Our mounting bases install on siding and other surfaces and can be installed before or after siding goes up.

Here’s the easy, NEAT way to mount a single or two-gang box between wood or metal studs with non-standard spacing.

Arlington’s SL18 steel SLIDERBAR™ looks great and saves about 20 minutes per box over cutting and nailing extra 2x4s.

F428SC: Can be positioned on the ceiling grid at the cross of the T-rails or on the straight away. For use on premium/reveal edge ceiling tiles, the box height adjusts by removing the tabs with pliers. Plastic hanger. For fixtures (only), up to 50 lbs. Includes 12ft support wire coil, installed NM cable connector, grid cover.

Two low voltage openings with built-in divider, an ultra-thin stamped steel flange, and flush-to-the-floor in-use and blank covers. Because the flange is ultra thin and the wiring device is recessed, these floor boxes reduce trip hazard caused by plugs protruding from the box.

Heavy-duty plastic. 5.5 inch non-metallic concrete floor box with six conduit hubs, four plugs, and multiple slots for positioning two low voltage dividers in the box.