Electrical Industry Articles and Stories

Look up in most U.S. kitchens and you’ll likely see recessed downlights shining back at you. These fixtures have been the go-to option for decades – not just in kitchens, but throughout the house – for providing area lighting that doesn’t interrupt a ceiling’s clean lines

In the constantly changing world of lighting technology, wireless fixture control marks a significant leap forward. These systems, defined by their ability to manipulate lighting conditions, without the need for hard-wiring, are swiftly becoming a vital tool for electrical contractors and lighting designers.

Uncle Bob and Aunt Betty's two-story farmhouse was a haven for my brother and me during our childhood. While it didn't boast modern amenities, the old-fashioned radiators under each window ensured a cozy warmth throughout the house. These radiators were a blessing during cold winters, providing a spot to dry our snow-soaked gloves.

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

Up until three years ago, I lived with a couple small boxes of spare fuses that sat on top of the water heater in the basement, ready to be drawn from should the rare combination of, say, the toaster and microwave operating at the same time happen to shut down power to the kitchen.

I'm working on upgrading the electrical outlets around the outside of our house. In addition to adding more receptacles around the perimeter, I'm finally getting around to "electrifying" the shed and lean-to in the backyard.