Electrical Industry Articles and Stories

Wall pack lighting is installed on the exterior walls of buildings where it provides needed illumination to ensure safety and security. This type of fixture is perfect for parking lots, pathways, exits, entrances, or wherever nighttime visibility is crucial.

Look up in most U.S. kitchens and you’ll likely see recessed downlights shining back at you. These fixtures have been the go-to option for decades – not just in kitchens, but throughout the house – for providing area lighting that doesn’t interrupt a ceiling’s clean lines

In the constantly changing world of lighting technology, wireless fixture control marks a significant leap forward. These systems, defined by their ability to manipulate lighting conditions, without the need for hard-wiring, are swiftly becoming a vital tool for electrical contractors and lighting designers.

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

I'm working on upgrading the electrical outlets around the outside of our house. In addition to adding more receptacles around the perimeter, I'm finally getting around to "electrifying" the shed and lean-to in the backyard.

Rooftop support systems are an integral part of conduit, piping, and mechanical installations that often go underappreciated. These unsung heroes of the rooftop world provide a stable and secure foundation for equipment, ensuring that everything from HVAC units to solar panels stays in place, regardless of weather conditions or external forces.