Allied Moulded Products, Inc.
Mind the Gap: Air-Sealing Options for Exterior Wall Outlets
Residential energy use today accounts for about 20% of U.S. greenhouse
gas emissions – though this figure varies widely by region and income
level. Certainly, getting more of our energy from renewable resources
can help reduce those emissions, but we also need to limit overall
energy demand in order to meet the emissions cuts necessary to blunt
climate change’s worst effects.
Light Efficient Design
Save Money, Energy, and Maintenance Time with LED Luminaires
I was talking to my brother, Mark, on the phone last night. We’d been
trying to connect all week and finally got the chance. I’m in Arkansas
and he’s in Arizona, so the time difference can be a pain.
We just missed each other the day before because he was over with the neighbors across the street.
Lutron Electronics Co., Inc.
Simple Strategies to Reduce Energy
In new construction, sustainable building practices are becoming the
norm. But even in existing buildings, simple strategies can be
implemented quickly and easily to address inefficiencies, reduce energy
use, improve comfort, and enhance productivity in the space.
Legrand/Pass & Seymour
Less Work to Meet Safety Requirements
Some facilities are changing their requirements for motor and appliance
installations. This could be due to OSHA Lock-out and Tag-out
requirements or NFPA 70E. The change is toward using pin and sleeve
devices instead of having a hard-wired installation.
Safety requirements often have the maintenance person checking for the
absence of voltage before touching. The rules are quite specific and are
enforced by OSHA.
Eaton Cutler-Hammer
Switchboards: The Cornerstone of Power Supply Dependability
Switchboards are critical to the dependability of any electrical power
installation because they represent that pivotal point at which incoming
power supply is divided into separate circuits, controlled and
protected by fuses and switchgear, metered, and then divided into a
number of functional units for its given applications. In general,
switchboards distribute power to transformers, panelboards, control
equipment, and to system loads.
Arlington Industries, Inc.
Bonding vs. Grounding: A Primer
Bonding and grounding are simple concepts, but, unfortunately, they’re
also easily confused with each other. Definitions of one term often get
wrapped up in the definitions of the other, and, before long, one can
begin thinking the words are interchangeable.
“Grounding” refers to the creation of a path from electrical equipment
to the earth. It is intended to protect equipment and help prevent fires
that might occur due to high voltages resulting from lightning strikes,
line surges or unintended contact with higher-voltage lines.