Steel City® RPT6 Recessed Poke-Through Floor Box

Thomas & Betts Corporation
Steel City® RPT6 Recessed Poke-Through Floor Box

Steel City® RPT6 recessed poke-through floor boxes, new from Thomas & Betts (T&B), provide maximized capacity for power and communications wiring in single-core drill locations at the second floor and above in commercial buildings.

The recessed service conceals devices below the floor level for 6-inch holes.

The Steel City RPT6 recessed poke-through floor box is compatible with off-the-shelf wiring devices, while its center compartment will accept GFCI outlets, as well as 20-amp and 30-amp twist-lock devices. The configurable compartment bottom junction box includes four plates enabling a contractor or specifier to run varying sizes of conduit through 1 ¼-, 1 ½- or 2-inch knockouts. Units are available with solid brass, brushed aluminum or black covers.

The Steel City RPT6 recessed poke-through floor box is rated for the UL® 263 two-hour fire test.

All T&B floor boxes are now available prewired and preconfigured though the eFab™ department.

Other Products by Thomas & Betts Corporation

  • Ty-Fast® Ag+® bacteria-resistant cable ties

    Ty-Fast® Ag+® bacteria-resistant cable ties

    Ty-Fast® Ag+® bacteria-resistant cable ties, new from Thomas & Betts (T&B), a member of the ABB Group, are the industry’s first cable ties to inhibit microbial growth, which helps to reduce infection rates and the spread of bacteria. Testing indicated that common bacteria on the cable ties’ surfaces is reduced by more than 99.9 percent.

  • ABB SENTRICITY™ Load Centers and Circuit Breakers

    ABB SENTRICITY™ Load Centers and Circuit Breakers

    SENTRICITY™ Load Centers and Circuit Breakers offer industrial-quality circuit protection for residential use by including energy-limiting technology that interrupts the circuit up to three times faster than conventional circuit breakers.

    The SENTRICITY family of products is named for its ability to act as a 24-hour sentry for the homeowner’s electrical circuits.

  • Carlon® Fittings

    Carlon® Fittings

    Carlon® fittings from Thomas & Betts (T&B), a member of the ABB Group, are among the only non-metallic fittings for electrical boxes that can be installed from either the inside or outside of the box.

    The new Carlon fittings are UL® Listed and CSA™ certified, and are certified for one or two sheathed cables.

  • T&B® Fittings Stainless Steel Conduit and Fittings

    T&B® Fittings Stainless Steel Conduit and Fittings

    T&B® Fittings Sand Cast Aluminum Form 7 Conduit Bodies, from Thomas & Betts (T&B), a member of the ABB Group, are made of CorroStall® aluminum alloy, which is among the most corrosion-resistant aluminum alloys. After 1,200 hours of 5-percent salt fog testing, the conduit bodies remained free of red rust and surface pitting.