Sperry Instruments Inc.
Measure Twice, Install Once: Dual-Purpose Meters for Successful Motor Installation
Three-phase motors run our industrial economy, powering everything from
conveyor lines and pumps to lathes and fans. These devices have been a
part of assembly plants and other industrial settings for generations
and they can run for 15 years or more when installed correctly and
maintained over time.
Lutron Electronics Co., Inc.
Install 3-way Lighting Control Without Needing Traveler Wires
I’ll bet this has happened to you. You’re elbows deep in a wiring
project, or lost in a trance-like state, figuring out a major
troubleshooting problem.
Suddenly, a tap on the shoulder and a quiet “excuse me” interrupts you, sending a jolt right down your spine.
King Innovation
Keeping Electrical Connections Dry in Wet and Damp Locations
Water and electricity don’t mix – that’s something we all learn at a
pretty early age. But still, there are times when even the wettest
locations require power. In applications from pool lighting to
irrigation systems and outdoor outlets, contractors are often called on
to make electrical connections that can remain watertight over years of
use.
Honeywell, Inc.
Smoke Detectors and Fire Alarms – Residential, Commercial, Industrial
All homes and workplaces need protection from fire. It’s part of
building codes everywhere. The type of system will vary depending on the
type of building, number of occupants, and intended use of the
structure.
Klein Tools, Inc.
Manufacturers Bringing Bright Ideas to New Flashlights
Flashlights used to be just, well, flashlights – handy tools for
bringing a little illumination to whatever task was at hand. They also
could be a little undependable in the old days. Battery strength was
always a question, especially if they hadn’t been used in a while.
GE Industrial Solutions by ABB
Lighting Automation Still Requires a Contactor
Lighting automation has bells and whistles, but a lighting contactor is
necessary to switch the actual lighting circuits. Properly selecting
lighting contactors can save installation and maintenance costs. What
are some of the important considerations in addition to the correct
voltage and current?