Electrical Industry Articles and Stories

Vertical cable supports are one of the electrical industry’s unsung heroes. Engineered to safely support non-armored cables in vertical raceways or risers, they can make the critical difference between power being connected or disconnected.

Wall pack lighting is installed on the exterior walls of buildings where it provides needed illumination to ensure safety and security. This type of fixture is perfect for parking lots, pathways, exits, entrances, or wherever nighttime visibility is crucial.

Industrial facilities must have an Emergency, Escape, and Rescue (EER) plan in place whose object is to ensure the safety of personnel during an emergency. Among other requirements, the plan must include the installation of bright, reliable emergency lighting for illuminating a pathway to safety.

Look up in most U.S. kitchens and you’ll likely see recessed downlights shining back at you. These fixtures have been the go-to option for decades – not just in kitchens, but throughout the house – for providing area lighting that doesn’t interrupt a ceiling’s clean lines

It’s not unusual that solar photovoltaic (PV) systems would require fuses – after all, these installations can carry substantial electrical loads, so overcurrent protection is critical to their safe operation. What is remarkable, though, are the conditions under which PV panels, their conductors, and their wiring can operate.

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.