Carlon® Fittings

Thomas & Betts Corporation
Carlon® Fittings
Carlon® fittings from Thomas & Betts (T&B), a member of the ABB Group, are among the only non-metallic fittings for electrical boxes that can be installed from either the inside or outside of the box.

The new Carlon fittings are UL® Listed and CSA™ certified, and are certified for one or two sheathed cables.

Other Products by Thomas & Betts Corporation

  • T&B Liquidtight Systems™ flexible metal conduit

    T&B Liquidtight Systems™ flexible metal conduit

    T&B Liquidtight Systems™ flexible metal conduit, from Thomas & Betts, a member of the ABB Group, complements T&B Liquidtight Systems fittings to provide a complete system solution for wet and corrosive environments.

    T&B Liquidtight Systems components are tested to the same global standards as enclosures to ensure a liquidtight installation in demanding applications.

  • Steel City® RPT6 Recessed Poke-Through Floor Box

    Steel City® RPT6 Recessed Poke-Through Floor Box

    Steel City® RPT6 recessed poke-through floor boxes, new from Thomas & Betts (T&B), provide maximized capacity for power and communications wiring in single-core drill locations at the second floor and above in commercial buildings.

    The recessed service conceals devices below the floor level for 6-inch holes.

  • T&B® Fittings Stainless Steel Conduit and Fittings

    T&B® Fittings Stainless Steel Conduit and Fittings

    T&B® Fittings Sand Cast Aluminum Form 7 Conduit Bodies, from Thomas & Betts (T&B), a member of the ABB Group, are made of CorroStall® aluminum alloy, which is among the most corrosion-resistant aluminum alloys. After 1,200 hours of 5-percent salt fog testing, the conduit bodies remained free of red rust and surface pitting.

  • T&B® Rigid Fittings Stainless Steel Drain Adapter

    T&B® Rigid Fittings Stainless Steel Drain Adapter

    T&B® Rigid Fittings Stainless Steel Drain Adapters from Thomas & Betts facilitate moisture drainage from electrical systems in ordinary locations where threaded connectors are not possible.

    They provide drainage of accumulated moisture in stainless steel enclosures with non-threaded connections, without the need for unsafe and cumbersome welding or improvised breather lines for caulking.