Appleton™ A-51™ LED Factory Sealed Luminaires Installation

Appleton™ A-51™ LED Factory Sealed Luminaires by Emerson are the ideal area/task lighting solution for hazardous locations requiring explosionproof, dust-ignitionproof ratings. Easy to install in new and retrofit applications, they utilize in the same mounting hoods as traditional incandescent A-51 luminaires with no rewiring required.

Related Videos

  • Arlington Industries Gangable Box

    Arlington Industries, Inc.

    Arlington Industries Gangable Box

    Arlington’s UL Listed gangable concrete floor boxes give installers the economical, convenient way to add receptacles in new concrete pours in commercial installations. Use the single gang box ‘as shipped’ or lock them together to build a two- or three-gang box. You decide.

  • Lutron LED Drivers – Guaranteed Dimming Performance

    Lutron Electronics Co., Inc.

    Lutron LED Drivers – Guaranteed Dimming Performance

    Take control of the LED opportunity with ultra-reliable, high-performance dimming drivers from Lutron. Select the brand, the dimming level, and the control method you desire for your application to ensure that what you get on the job is what you expect.

  • Mersen Minute: Embedded Heat Pipe Air Cooled Heat Sinks

    Mersen

    Mersen Minute: Embedded Heat Pipe Air Cooled Heat Sinks

    By incorporating heat pipes onto the surface of an air cooled heat sink, high concentration of heat from power electronics can be spread out over a larger area are very quickly. This technique can greatly improve the cooling performance of the heat sink for applications such as SiC and Power Amplifier.

  • Mighty-Align® SLP Series Steel Slip EMT Connectors

    Bridgeport Fittings, Inc.

    Mighty-Align® SLP Series Steel Slip EMT Connectors

    Mighty-Align® SLP Series Slip EMT Connectors. No more wasting time with short conduit cuts. Used to connect EMT to an enclosure in tight or limited access applications. Simply slide fitting onto conduit to the end stop, position EMT, and then slide the connector into the K.O. Align the end of the EMT with the sight window for proper pipe engagement, and tighten set screw.