Electrical Industry Articles and Stories

Wall pack lighting is installed on the exterior walls of buildings where it provides needed illumination to ensure safety and security. This type of fixture is perfect for parking lots, pathways, exits, entrances, or wherever nighttime visibility is crucial.

Look up in most U.S. kitchens and you’ll likely see recessed downlights shining back at you. These fixtures have been the go-to option for decades – not just in kitchens, but throughout the house – for providing area lighting that doesn’t interrupt a ceiling’s clean lines

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

It’s hard to believe that it was just three years ago that much of the country was on red alert status thanks to Covid. Researchers were still learning more about the new virus, but one thing they were sure of was that it spread through the air, which made air purification systems a new priority for any place people gathered in large numbers.

Occupancy sensors are quickly becoming a regulatory requirement in many commercial spaces, thanks to evolving energy codes seeking to wring out kilowatt-hours of energy savings anywhere it’s possible.

The beauty of recessed can downlights is their seeming sleekness. They barely interrupt the ceiling plane, which can be an especially big bonus in homes with lower ceiling heights and in clean-lined contemporary room plans.